Design Principle Of Mold

Views: 0 Author: Site Editor Publish Time: 2020-01-05 Origin: Site

Because different molding dies have been applied in many fields, and the manufacturing technology of the mold has also changed to a certain extent in these years, the general design rules of vacuum blister molding dies are summarized in this part.

The design of vacuum blister molding mold includes batch size, molding equipment, accuracy conditions, geometric shape design, dimensional stability and surface quality.

1. For batch size experiments, the mold output is small, and it can be made of wood or resin. However, if the experimental mold is to obtain data on shrinkage, dimensional stability, and cycle time of the product, a single cavity mold should be used for the experiment, and it can be guaranteed to be used under conditions. Molds are generally made of gypsum, copper, aluminum, or aluminum-steel alloys, and aluminum-resin is rarely used.

2. Geometric shape design. When designing, often consider the dimensional stability and surface quality. For example, product design and dimensional stability require the use of female molds (concave molds), but products with higher surface gloss require the use of male molds (convex molds). In this way, the plastic purchaser will consider the two Point so that the product can be made under the conditions of **. Experience has shown that designs that do not meet actual processing conditions often fail.

3. Dimensional stability. During the molding process, the contact surface of the plastic part with the mold is better than the dimensional stability of the part leaving the mold. If the thickness of the material is required to be changed in the future due to the rigidity of the material, the male mold may be converted into a female mold. The dimensional tolerance of the plastic part must not be less than 10% of the shrinkage.

4. The surface of the plastic part, as far as the molding material can cover, the surface structure of the visible surface of the plastic part should be formed at the point of contact with the mold. If possible, do not touch the smooth surface of the plastic part with the mold surface. It's like the case of making bathtubs and laundry tubs with negative molds.

5. Modification. If a mechanical horizontal saw is used to saw off the clamping edge of the plastic part, there must be at least 6-8mm margin in the height direction. Other dressing tasks, such as grinding, laser cutting, or jetting, also allow margins. The gap between the cutting edges of the cutting edge die is small, and the distribution width of the punching die when trimming is also small. These should be paid attention to.

6. Shrinkage and deformation, plastic is easy to shrink (such as PE), some plastic parts are easy to deform, no matter how to prevent, plastic parts will deform during the cooling stage. Under this condition, it is necessary to change the shape of the forming mold to adapt to the geometric deviation of the plastic part. For example: although the plastic wall remains straight, its reference center has deviated by 10mm; the mold base can be raised to adjust the shrinkage of this deformation.

7. Shrinkage. The following shrinkage factors must be taken into consideration when manufacturing blister molding molds. ① The molded product shrinks. If the shrinkage of the plastic cannot be clearly known, take a sample or possess it by experiment with a similarly shaped mold. Note: This method can only have the shrinkage rate, not the deformation size. ② Shrinkage caused by the adverse effects of intermediate media, such as ceramics, silicone rubber, etc. ③ Shrinkage of the material used in the mold, such as shrinkage when casting aluminum.

Design Principle Of Mold

Main Products

Related News

About Company

Quick Links

Product Category

Our New Letter